Siemens SINUMERIK 840Di - Service Menu

06.03
6.5 Service menu
6-193
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
6.5 Service menu
PLEASE SELECT
1 Install/Update SINUMERIK System
2 SINUMERIK Tools and Options
3 DOS Shell
4 Start Windows NT (Service Mode)
5 SINUMERIK System Check
7 Backup/Restore
8 Start PC Link
9 Reboot (warm restart)
P 840Di Services
Your Choice [1,2,3,4,5,7,8,9,P] ?
The service menu provides the following functions at DOS level:
S Install/Update SINUMERIK System
Installation and addition or updating of the SINUMERIK system
S SINUMERIK Tools and Options
Loading additional tools and enabling options
S DOS Shell
The DOS command interpreter is started
S Start Windows NT
WinNT is started
S SINUMERIK System Check
Consistency test and, if necessary, recovery (SCANDISK) of the file system
S Backup/Restore
Hard disk backup/restore with Norton Ghostt
S Start PC Link
Installation of PC link software (Interlink/Interserve) using CD-ROM
S Reboot
Restart of the system
S 840Di services
Activating 840Di-specific functions
The service menu is started with the operating sequence “Cursor down” and
“Enter”.
The service menu is started from the boot manager with the operating se-
quence “Cursor down” and “Enter”.
A password of protection levels 0–2 is required to execute the service menu:
– System
– Manufacturer
– Service.
Functions
Activation
6 Turnin
g
On and Ram
p
U
p