Siemens SINUMERIK 840Di - NC;PLC Diagnosis (840 Di SW 2.3 and Higher)

06.03
10.10 NC/PLC diagnosis (840Di SW 2.3 and higher)
10-395
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
10.10 NC/PLC diagnosis (840Di SW 2.3 and higher)
10.10.1 Menu: Diagnostics
The menu for NC/PLC diagnosis is located under the follwoing operating path:
S Operating area switchover > Diagnosis > NC/PLC Diagnosis > Diagnosis
NCK reset
General NCK reset
6 Running
MPF0
Program aborted
ROV
CHAN1 AUTOStart-up
RUN–P
RUN
STOP
General PLC reset
PLC MRES
STOP
SF–DP
BUSF
FORCE
BATF
BATL
SF
RUN
PLC
RUN
PLC
RUN–P
PLC
STOP
General
NCK reset
NCK
Reset
General
PLC reset
PLC
MRES
NCK latency times
Channel RESET
200
0
ms
Time (sec)
730
Diagnostics
Settings
Acknowledge
alarm 4065
>>
NCK PLC
Fig. 10-37 Menu: NC/PLC diagnosis
The NCK group combines the following functions:
S NCK status
The output field displays the current status of the NCK:
– 0 not started
– 1 started
– 2 Initialize data
– 3 Initialize data
– 4 Start–up
– 5 Wait for PLC
– 6 Running
– F NCK error
Operating path
Group: NCK
10 NC Start-U
p
with HMI Advanced