06.03
1.3 Notes on start-up
1-35
Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
1.3 Notes on start-up
The present SINUMERIK 840Di manual describes the start-up of the following
components:
S SINUMERIK 840Di NC and PLC
S MPI Bus
S PROFIBUS DP
For the start-up of the components used in conjunction with the SINUMERIK
840Di, such as:
S operator panel fronts (e.g. SINUMERIK OP 012)
S PROFIBUS DP drives (e.g. SIMODRIVE 611 universal),
please refer to the relevant documentation.
Notice
It is recommended to carry out the start-up of the SINUMERIK 840Di in the
order of the sections of the present Manual.
To start up the SINUMERIK 840Di, the following software is needed, which is
part of a SINUMERIK 840Di:
S To start up the SINUMERIK 840Di NC:
– 840Di start-up
– SinuCom NC
S To start up PLC, MPI and PROFIBUS DP communication:
– DriveOM
– SlaveOM
– Basic PLC program
S To start up SIMODRIVE 611 universal drives
– SinuCom U.
To start up the SINUMERIK 840Di, the following software is needed, which is
not part of a SINUMERIK 840Di:
S To start up PLC, MPI and PROFIBUS DP communication:
– SIMATIC Manager STEP7: Version 5, Service Packs 1 and 2.
To start up the SINUMERIK 840Di, the following hardware components are ad-
ditionally needed:
S a programming device with MPI interface, e.g. PG740:
Software
Additional soft-
ware
Additional hard-
ware
1 General on the SINUMERIK 840Di
To Next Page
Loading...
