Siemens SINUMERIK 840Di - Dry Run of Axis

06.03
12.2 Dry run of axis
12-413
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
12.2 Dry run of axis
– Select JOG mode
– Traverse axis using direction key
Does the
axis move?
Check enabling signals on drive
I/RF module: Terminal 63 (pulse enable)
64 (drive enable)
48 (DC link start)
FDD module: 663 (pulse enable)
Check interface signals (DB 31–48)
DBB0 Feedrate override switch
DBX1.7 Compensation active
DBX1.5/1.6 Position measuring system 1/2
DBX1.4 Follow-up mode
DBX1.3 Axis disable
DBX2.2 Delete distance to go
DBX2.1 Controller enable
DBX4.3 Feed stop/spindle stop
DBX5.0-5.5 JOG-INC
DBX4.6/4.7 Traversing keys
DBX20.1 HLGSS (Drive)
DBX21.7 Pulse enable (611D)
Check machine data
MD32000–32050 Velocities
MD36000–36620 Monitoring functions
MD32110 Sign actual value
MD32250 Nominal output voltage
1)
MD32260 Nominal output speed
Service display
Traversing
direction
OK?
Check:
MD32100: AX_MOTION_DIR
Set path 10mm
Is path
evaluation
O.K.?
Check:
MD31000–31080: (encoder matching)
no
yes
yes
yes
1
no
no
1) Speed setpoint matching
– ADI4: –> MD32250 00
– SIMODRIVE 611 universal / E; POSMO CD/CA, SI
–> MD32250 = 0
12 Dr
y
Run of Axis and S
p
indle