Siemens SINUMERIK 840Di - Installing Simocom U

06.03
9.2 Installing SimoCom U
9-271
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
9.2 Installing SimoCom U
SimoCom U is part of the 611U toolbox supplied with the SINUMERIK 840Di in
directory:
S <Installationspfad>\siemens\611UToolbox\SimoComU
To instal SimoCom U on the PCU, start file setup.exe and follow the further
installation instructions.
Note
Before installing SimoCom U, please observe the appropriate notes in the file:
<installation path>\readme.txt.
SimoCom U provides the following functions:
– Make an online connection to the drives
– Upgrade the firmware
– Optimize the control parameters
– Traverse the axes
– Diagnose the drive status.
After installation, the documentation for SimoCom U is available electronically.
Use the menu command Help in SimoCom U to call information on the topics:
– Short introduction...
– How to Use WINDOWS Help...
– Help Topics...
– Key Operation...
– Wiring...
– About SimoCom U...
In addition, for a detailed description on SimoCom U, please refer to:
/FBU/ SIMODRIVE 611 Universal, Description of Functions
J
Installation
Scope of available
functions
Online help
References
9 Drive Start-U
p
(
Preconditions
)