Siemens SINUMERIK 840Di - SINUMERIK System Check

06.03
6.5 Service menu
6-196
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
S Current SINUMERIK HMI environment
Before you start SINUMERIK HMI, the backed up files of the above directo-
ries are loaded.
Select Start Windows NT (ServiceMode) with key “4”.
Following menu:
PLEASE SELECT
1 Standard Windows NT (without starting SINUMERIK HMI)
4 Original SINUMERIK HMI environment
5 Current SINUMERIK HMI environment
9 Return to Main Menu
Your Choice [1,4,5,9] ?
After you have selected the function, the system is rebooted. The function is
actually executed during the ensuing ramp-up of Windows NT before the HMI
system software is started.
Note
S The SINUMERIK desktop can also be started if you press key “3” while SI-
NUMERIK background image is being displayed during ramp-up of the
PCU (time range: 3 sec).
S The HMI environment can also be set on the SINUMERIK desktop by start-
ing the functions:
– Original SINUMERIK HMI Environ
– Current SINUMERIK HMI Environ.
6.5.5 SINUMERIK System Check
PLEASE SELECT
1 Install/Update SINUMERIK System
2 SINUMERIK Tools and Options
3 DOS Shell
4 Start Windows NT (Service Mode)
5 SINUMERIK System Check
7 Backup/Restore
8 Start PC Link
9 Reboot (warm restart)
P 840Di Services
Your Choice [1,2,3,4,5,7,8,9,P] ?
Under menu item: SINUMERIK System CHECK, the following system compo-
nents are checked:
S Hard disk of the PCU
Partitions C:, D:, E: and F: are tested.
Select SINUMERIK System CHECK with key “5”.
Operator action
Operator action
6 Turnin
g
On and Ram
p
U
p