Siemens SINUMERIK 840Di - Data Descriptions (MD)

06.03
10.7 Loadable compile cycles (SW 2.2 and higher)
10-392
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
You can activate the entire technological function in the individual NC channels
or individual subfunctions via the above mentioned general NCK machine date.
For a description of the machine data, please see Subsection 10.7.4, page
10-392.
The individual technological functions are described in:
/FB3/ Description of Functions Special Functions
Sections TE1 to TE8
The compile cycles loaded in the FSS NCK are displayed together with the re-
spective version of HMI Advanced (option) in the following menu:
Operating area switchover > Service > Version > Compile cycles
10.7.4 Data descriptions (MD)
60900 + i
with i = 0. 1. 2nd 3 ...
CC_ACTIV_IN_CHAN_XXXX[n]
with: XXXX = function identifier, n = 0 or 1
MD number n = 0: Activation of the technological function in the NC channels
n = 1: Additional functions within the technological function
Default settings: 0 min. input limit: 0 max. input limit: FFFF
Changes valid after RESET Protection level: 2 / 7 Unit: –
Data type: UINT16 valid from SW: 2.2
Meaning: Activation of the technological function in the NC channels
The technological function is activated in the NC channels via the MD with the index n = 0.
Bit 0 = 1: Technological function activated in NC channel 1
Bit n = 1: Technological function activated in NC channel n+1
For more details about which NC channels a technological function can be activated,
please refer to the manuals below.
Additional functions within the technological function:
Additional functions within the individual technological function can be activated via the MD
with the index n = 1. See References below.
References: /FB3/ Description of Functions Special Functions TE1 – TE8.
References
Version display:
HMI Advanced
(option)
General
machine data
10 NC Start-U
p
with HMI Advanced