06.03
6.2 First ramp-up
6-175
Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
6.2 First ramp-up
6.2.1 Basic ramp-up of the system software (SW 2.2 and higher)
After a basic start-up described in the following, the following prerequisites must
be provided:
S SINUMERIK 840Di-NC and PLC are operated in cyclic operation
S If a machine control panel is connected, no alarms or messages should be
present
S The displayed axes of the NC can be traversed by simulation.
At delivery, the hard disk of the PCU is already partitioned for running SINUM-
ERIK 840Di and any other SINUMERIK applications. The software applications
included in the delivery are ready for installation and are located on the hard
disk under D:\Setup\Apps\<Application1> . . . <Application n>.
C:
FAT16
Name: DOS
Contents: DOS 6.2
Tools
D:
FAT16
Name: Install
Contents: Images,
Setups,
Updates
E:
NTFS
Name: WinNT
Contents: WinNT 4.0
F:
NTFS
Name: 840Di system
Contents: empty
Primary partition Primary partitionPrimary partitionExtended partition
with logic drive
active
Fig. 6-1 Partitioning of the harddisk
When the PCU is first booted, the following menu is displayed:
Welcome to SINUMERIK !
These SINUMERIK products will be installed now:
<Application 1> <Version>
<Application n> <Version>
: :
Install NOW
CANCEL installing
Install at NEXT REBOOT
: :
Objective of basic
ramp-up
Delivery state
Installing the
software
6 Turnin
On and Ram
U
To Next Page
Loading...
