Siemens SINUMERIK 840Di - Page 147

06.03
5.4 Machine control panel (MCP)
5-147
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
5. Load the modified blocks into the PLC and then restart the PLC.
6. After communication with the PLC has been established, the LEDs on the
MCP front stop flashing.
The LED of the basic settings for:
S Mode: Referencing
S Spindle Stop
S Feed hold
light up continuously.
5 MPI Communication