Siemens SINUMERIK 840Di - Page 198

06.03
6.5 Service menu
6-198
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Select 840Di Services with key “P”.
Following menu:
PLEASE SELECT
1 Set PLC-Mode to STOP
2 Set PLC-Mode to RUN
3 Set PLC-Mode to RUNP
9 Return to Main Menu
Your Choice [1,2,3,4,9] ?
After you have selected the function, the system is rebooted. While the PCU is
started up, the following message box is displayed indicating execution of an
840Di Service:
SINUMERIK 840Di NCK/PLC
Alarm: System order executed.
The message box must be acknowledged with “OK”.
The selected function is executed after ramp-up of the corresponding SINUM-
ERIK 840Di component.
Operator action
6 Turnin
g
On and Ram
p
U
p