Siemens SINUMERIK 840Di - Page 278

06.03
10.2 Machine and setting data
10-278
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
The following default passwords are defined for the protection levels 1 though 3:
Protection level 1 SUNRISE
Protection level 2 EVENING
Protection level 3 CUSTOMER
Notice
A system power-up with loading the default machine data (after “Delete NCK
data”, e.g. using 840Di Start-up) will reset the passwords to the default values.
In order to provide safe access protection, the default passwords should be
modified.
The protection levels of machine and/or setting data can be modified both with
respect to complete machine or setting data ranges and for single data.
Data areas
Table 10-4 Protection levels: Machine data
Number Identifier Name Ref.
MMC machine data ($MM_....)
9200 USER_CLASS_READ_TOA Protection level “Read tool offsets”
9201 USER_CLASS_WRITE_TOA_GEO Protection level “Write tool geometry”
9202 USER_CLASS_WRITE_TOA_WEAR Protection level “Write tool wear data”
9203 USER_CLASS_WRITE_FINE Protection level “Write fine”
9204 USER_CLASS_WRITE_TOA_SC Protection level “Change additive tool offsets”
9205 USER_CLASS_WRITE_TOA_EC Protection level “Change tool setup offsets”
9206 USER_CLASS_WRITE_TOA_SUPVIS Protection level “Change tool monitoring limit
values”
9207 USER_CLASS_WRITE_TOA_ASSDNO Change assigned D-No. of a tool edge
9208 USER_CLASS_WRITE_MAG_WGROUP Change wear group magazine location/mag.
9209 USER_CLASS_WRITE_TOA_ADAPT Protection level “Tool adapter data”
9210 USER_CLASS_WRITE_ZOA Protection level “Write settable zero offset”
9213 USER_CLASS_OVERSTORE_HIGH Protection level “Extended overstore”
9214 USER_CLASS_WRITE_PRG_CONDIT Protection level “Program control”
9215 USER_CLASS_WRITE_SEA Protection level “Write setting data”
9218 USER_CLASS_SELECT_PROGRAM Protection level “Program selection”
9219 USER_CLASS_TEACH_IN Protection level “TEACH IN”
9220 USER_CLASS_PRESET Protection level “PRESET”
9221 USER_CLASS_CLEAR_RPA Protection level “Delete R parameters”
9222 USER_CLASS_WRITE_RPA Protection level “Write R parameters”
9231 USER_CLASS_WRITE_RPA_1 Protection level for the first RPA area
9232 USER_BEGIN_WRITE_RPA_1 Start of the first RPA area
9233 USER_END_WRITE_RPA_1 End of the first RPA area
9234 USER_CLASS_WRITE_RPA_2 Protection level for the second RPA area
Default
passwords
Redefining
protection levels
10 NC Start-U
p
with HMI Advanced