Siemens SINUMERIK 840Di - Page 375

06.03
10.5 Axes and spindles
10-375
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Speed
Max. encoder limit frequency
Max. spindle speed
Min. spindle speed of current gear stage
IS: Axis/spindle stopped (n<nmin) Speed range of spindle
Max. spindle speed of current gear stage
Programmable spindle speed limiting LIMS
Programmable minimum spindle speed G25
or spindle chuck Speed range of current gear stage Speed range of current gear stage limited by G25 and G26 Speed range of current gear stage with constant cutting rate G96 and G97 IS: Referenced/synchronized
Programmable spindle speed limitation G26
0
Max. velocity/speed “Axis/spindle stopped”
Fig. 10-32 Ranges of spindle monitoring functions/speeds
/FB1/ Description of Functions, Basic Machine,
S1 Spindles
Section: Spindle monitoring
References
10 NC Start-U
p
with HMI Advanced