Siemens SINUMERIK 840Di - Page 377

06.03
10.5 Axes and spindles
10-377
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Number Ref.NameIdentifier
Axis-specific ($MA_ ...)
35210 GEAR_STEP_POSCTRL_ACCEL[n] Acceleration in position control mode
35220 ACCEL_REDUCTION_SPEED_POINT Speed limit for reduced acceleration
35230 ACCEL_REDUCTION_FACTOR Reduced acceleration
35300 SPIND_POSCTRL_VELO Position control threshold speed
35350 SPIND_POSITIONING_DIR Direction of rotation when positioning with the
spindle not synchronized
35400 SPIND_OSCILL_DES_VELO Oscillation speed
35410 SPIND_OSCILL_ACCEL Acceleration on oscillation
35430 SPIND_OSCILL_START_DIR Start direction on oscillation
35440 SPIND_OSCILL_TIME_CW Oscillation time for M3 direction
35450 SPIND_OSCILL_TIME_CCW Oscillation time for M4 direction
35500 SPIND_ON_SPEED_AT_IPO_START Feedrate enable for spindle in setpoint range
35510 SPIND_STOPPED_AT_IPO_START Feed enable with the spindle stopped
35590 PARAMSET_CHANGE_ENABLE Parameter set specification possible from PLC A2
36060 STANDSTILL_VELO_TOL Threshold speed “Axis/spindle stopped” A3
36200 AX_VELO_LIMIT Threshold value for velocity monitoring A3
Table 10-48 Spindle: Setting data
Number Identifier Name Ref.
Spindle-specific ($SA_ ...)
42600 JOG_FEED_PER_REF_SOURCE Revolutional feedrate control in JOG mode V1
42800 SPIND_ASSIGN_TAB Spindle number converter
42900 MIRROR_TOOL_LENGTH Mirror tool length compensation W1
42910 MIRROR_TOOL_WEAR Mirror wear data of tool length compensation W1
42920 WEAR_SIGN_CUTPOS Mirror wear data of processing level W1
42930 WEAR_SIGN Invert signs of all wear data W1
42940 TOOL_LENGTH_CONST Keep the assignment of the tool length compo-
nents when changing the processing level
(G17 to G19).
W1
43210 SPIND_MIN_VELO_G25 Programmable spindle speed limiting G25
43220 SPIND_MAX_VELO_G26 Programmable spindle speed limiting G26
43230 SPIND_MAX_VELO_LIMS Programmable spindle speed limiting G96
43300 ASSIGN_FEED_PER_REF_SOURCE Revolutional feedrate for positioning
axes/spindles
V1, P2
Table 10-49 Spindle: Interface signals
DB number Bit, Byte Name Ref.
Axis-specific Signals from PLC to axis/spindle
31, ... 0 Feed override V1
31, ... 1.7 Override active V1
Setting data
Interface signals
10 NC Start-U
p
with HMI Advanced