Siemens SINUMERIK 840Di - Page 387

06.03
10.6 Digital and analog I/O devices
10-387
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Table 10-50 Digital and analog I/Os: Machine data
Number Identifier Name Ref.
General ($MN_ ...)
10300 FASTIO_ANA_NUM_INPUTS Number of active analog NC inputs
10310 FASTIO_ANA_NUM_OUTPUTS Number of active analog NC outputs
10320 FASTIO_ANA_INPUT_WEIGHT Weighting factor for analog NC inputs
10330 FASTIO_ANA_OUTPUT_WEIGHT Weighting factor for analog NC outputs
10350 FASTIO_DIG_NUM_INPUTS Number of active digital NC input bytes
10360 FASTIO_DIG_NUM_OUTPUTS Number of active digital NC output bytes
10362 HW_ASSIGN_ANA_FASTIN Hardware assignment of the external analog NC
inputs
10364 HW_ASSIGN_ANA_FASTOUT Hardware assignment of the external analog NC
outputs
10366 HW_ASSIGN_DIG_FASTIN Hardware assignment of the external digital NC
inputs
10368 HW_ASSIGN_DIG_FASTOUT Hardware assignment of the external digital NC
outputs
10380 HW_UPDATE_RATE_FASTIO Update rate of the synchronous external NC I/Os
10382 HW_LEAD_TIME_FASTIO Lead time of the synchronous external NC I/Os
10384 HW_CLOCKED_MODULE_MASK Synchronous processing of the external NC I/Os
10394 PLCIO_NUM_BYTES_IN Number of directly readable input bytes of the PLC
I/Os
10395 PLCIO_LOGIC_ADDRESS_IN Start address of the directly readable input bytes of
the PLC I/Os
10396 PLCIO_NUM_BYTES_OUT Number of directly writeable output bytes of the
PLC I/Os
10397 PLCIO_LOGIC_ADDRESS_OUT Start address of the directly writeable
output bytes of the PLC I/Os
10530 COMPAR_ASSIGN_ANA_INPUT_1 Hardware assignment of the NC analog inputs for
comparator byte 1
10531 COMPAR_ASSIGN_ANA_INPUT_2 Hardware assignment of the NC analog inputs for
comparator byte 2
10540 COMPAR_TYPE_1 Parameterization for comparator byte 1
10541 COMPAR_TYPE_2 Parameterization for comparator byte 2
Channel-specific ($MC_ ...)
21220 MULTFEED_ASSIGN_FASTIN Assignment of the input bytes of the NC I/Os for
“Several feedrates in a block”
V1
Table 10-51 Digital and analog I/Os: Setting data
Number Identifier Name Ref.
General ($SN_ ...)
41600 COMPAR_THRESHOLD_1 Threshold values for comparator byte 1
41601 COMPAR_THRESHOLD_2 Threshold values for comparator byte 2
Machine data
Setting data
10 NC Start-U
p
with HMI Advanced