Siemens SINUMERIK 840Di - Page 462

06.03
15.2 Software installation/update
15-462
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
5. Now switch on the PCU (again) and choose the menu item “Service menu”
(hidden) from the menu of the boot manager.
The following menu will appear:
PLEASE SELECT
1 Install/Update SINUMERIK System
2 SINUMERIK Tools and Options
3 DOS Shell
4 Start Windows NT (Service Mode)
5 SINUMERIK System Check
7 Backup/Restore
8 Start PC Link
9 Reboot (warm restart)
P 840Di Services
Your Choice [1,2,3,4,5,7,8,9,P] ?
6. Choose Install/Update SINUMERIK System using the key “1”.
The system prompts you to enter a password:
7. Type one of the passwords of protection levels 0–2.
– System
– Manufacturer
– Service.
Following menu:
PLEASE SELECT MEDIUM:
1 Install from Floppy Disk
2 Install via Serial/Parallel Line
3 Install from Network Drive
5 REBOOT
9 Return to Main Menu
Your Choice [1,2,3,5,9] ?
8. From the following menu, choose the menu item Install via Serial/Parallel
Line using the key “2”.
The software to be installed is now transferred from the ext. computer
(PG/PC) to the PCU into the directory D:\INSTALL.
If the transfer is completed, a power-up of the PCU following the Windows
NT procedure is carried out and the software that is to be found under
D:\INSTALL is installed automatically.
9. Exit the Server mode on the external computer (PG/PC):
Key combination: Alt + F4
15 SW Installation/U
p
date and Data Backu
p