Siemens SINUMERIK 840Di - Page 465

06.03
15.2 Software installation/update
15-465
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
The drive display in the menu under “Client”, e.g. as G: means that drive D:
of the PCU can be addressed from the ext. computer (PG/PC) as drive G: .
8. Now copy the software to be installed from the ext. computer into the drive
D:\INSTALL of the PCU.
copy <path>\*.* G:\INSTALL\
9. If the copying process is complete, exit INTERSVR on the PCU (key com-
bination: Alt + F4).
When the control is booted for the next time under Windows NT, the software
(setup.exe) contained in the installation directory D:\INSTALL of the PCU is
installed automatically.
15 SW Installation/U
p
date and Data Backu
p