Siemens SINUMERIK 840Di - Page 520

06.03
A-520
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Program test
Random Access Memory in which data can be read and written
Rapid Override
R-Parameter Active: Identifier for R parameters
Serial interface
Request To Send: Control signal on serial data interfaces
Single Block
Setting data
Setting Data Active: Identifier for setting data
Soft key
Skip: Skip block
Synchronous Linear Motor
Sub Program File
Static RAM (non-volatile)
Synchronous Rotary Motor
Spindle pitch for error compensation
Synchronous Serial Interface (interface type)
Status word
Software
Software limit switch
Tool
Tool Change
Testing Data Active: Identifier for machine data
Tool Offset
Tool Offset Active: Identifier for tool offsets
Tool Radius Offset
Transistor-Transistor Logic (interface type)
Data interface between NC and PLC
Tool Coordinate System
Zero Offset Active: Identifiere for zero offset
PRT
RAM
ROV
RPA
RS-232
RTS
SBL
SD
SEA
SK
SKP
SLM
SPF
SRAM
SRM
SSFK
SSI
STW
SW
SW limit switch
T
TC
TEA
TO
TOA
TRC
TTL
VDI interface
WCS
ZOA
A
Abbreviations