Siemens SINUMERIK 840Di - Page 81

06.03
2.7 SINUMERIK Industrial PC
2-81
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
2.7 SINUMERIK Industrial PC
2.7.1 SINUMERIK PCU 50
*) orientation with reference
to operation with OP 012
top
*)
**) Fixing screws
Housing cover
**)
**)
Fig. 2-22 PCU 50: Perspective view with installed hard disk drive
Designation Order No. (MLFB)
PCU 50 as spare part with Windows NT 4.0 US, with-
out MCI board:
PCU 50 333MHz, 128MB 6FC5 210-0DF01-0AA0
PCU 50 500MHz, 128MB 6FC5 210-0DF05-0AA0
PCU 50 566MHz, 128MB 6FC5 210-0DF20-0AA0
PCU 50 1.2GHz, 256MB 6FC5 210-0DF22-0AA0
Together with the MCI board, the SINUMERIK industrial PC “PCU 50” serves as
the basis for the SINUMERIK 840Di control system. The key features of the
PCU 50 are as follows:
S Processor versions:
– Pentium II 333MHz, 128MB SDRAM
– Pentium III 500MHz, 128MB SDRAM
– Celeron 566MHz, 128MB SDRAM
– Celeron 1.2GHz, 256MB SDRAM
S Hard disk min. 4.8GB (replaceable)
S Windows NT 4.0 operating system US version
Order number
Features
2 Hardware Descri
p
tions