Siemens SINUMERIK 840Di - Page 96

06.03
2.12 I/O Module PP72/48
2-96
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Interface description of the digital input/output interfaces (X111/X222/X333):
S Connector: 50-pin ribbon cable connector
S Pin assignment on each connector.
Table 2-19 Pin assignment (X111/X222/X333)
Pin Signal designation Type
1)
Pin Signal designation Type
1)
1 M VO 26 Input 2.7 I
2 P24OUT VO 27 – –
3 Input 0.0 I 28 – –
4 Input 0.1 I 29 – –
5 Input 0.2 I 30 – –
6 Input 0.3 I 31 Output 0.0 O
7 Input 0.4 I 32 Output 0.1 O
8 Input 0.5 I 33 Output 0.2 O
9 Input 0.6 I 34 Output 0.3 O
10 Input 0.7 I 35 Output 0.4 O
11 Input 1.0 I 36 Output 0.5 O
12 Input 1.1 I 37 Output 0.6 O
13 Input 1.2 I 38 Output 0.7 O
14 Input 1.3 I 39 Output 1.0 O
15 Input 1.4 I 40 Output 1.1 O
16 Input 1.5 I 41 Output 1.2 O
17 Input 1.6 I 42 Output 1.3 O
18 Input 1.7 I 43 Output 1.4 O
19 Input 2.0 I 44 Output 1.5 O
20 Input 2.1 I 45 Output 1.6 O
21 Input 2.2 I 46 Output 1.7 O
22 Input 2.3 I 47 DOCOMx VI
23 Input 2.4 I 48 DOCOMx VI
24 Input 2.5 I 49 DOCOMx VI
25 Input 2.6 I 50 DOCOMx VI
1) VI Voltage Input
VO Voltage Output
I Signal Input
O Signal Output
x with x = 1,2,3
Digital input/out-
puts
(X111/X222/X333)
2 Hardware Descri
p
tions