Siemens SIPROCESS GA700 Operating Instructions

Edition Comment
01/2022 General expansion and updating of the document
07/2023 Additions regarding CSA certi󹪝cation
1.3 Purpose
The device is designed for the concentration analysis of gases in gas mixtures. Depending on the
installed analyzer module, di󹪜erent gases can be examined.
Use the device only for measuring/analysis of gas concentrations in gas mixtures according to
the information in section"Technical speci󹪝cations (Page161)".
It is not permissible to use this device as a gas warning unit.
Note
Aggregate state of examined substances
The system can only be used for gaseous samples.
Note
This device meets the requirements of NAMUR Recommendation 53.
Note
Use in home environment
This equipment of Class A Group 1 is intended solely for use in industrial areas.
If used in homes, the device may cause radio interference.
Note
For more information on the compatibility of the hardware and 󹪝rmware, refer to:
Siemens Industry Online Support (https://support.industry.siemens.com/cs/de/en/ps/17731).
You will 󹪝nd more information in the operating instructions, see
"References (Page179)".
1.4 Field of application
These operating instructions only describe non explosion-proof SIPROCESS GA700 wall-
mounted devices. You can 󹪝nd information about explosion-poof SIPROCESS GA700 devices in
the compact operating instructions "Devices in explosion-proof designs".
A SIPROCESS GA700 wall-mounted device consists of a housing for wall mounting into which
up to two replaceable analysis modules can be inserted. The analyzer modules are selected
according to the measuring task and local conditions.
Introduction
1.4Field of application
Wall-mounted device
10 Operating Instructions, 07/2023, A5E31930403-AB

Siemens SIPROCESS GA700 Specifications

General

Brand	Siemens
Model	SIPROCESS GA700
Category	Measuring Instruments
Language	English