Siemens SIPROCESS GA700 - Display

WARNING
Violation of the maximum permissible operating pressure
Danger of injury or poisoning
The maximum permissible operating pressure depends on the device version. The device can
be damaged if the maximum permissible operating pressure is exceeded. Hot, toxic and
corrosive process media can be released.
• Make sure that the device is suitable for the maximum permissible operating pressure of
your system. Refer to the information on the nameplate and/or in section "Technical
speci󹪝cations (Page161)".
WARNING
Insu󹪟cient ventilation
Risk of 󹪝re
The device may overheat or start burning in the case of insu󹪟cient ventilation.
• Make sure that the room is su󹪟ciently ventilated.
Refer to the information in section "Technical speci󹪝cations (Page161)".
NOTICE
Improper installation
The device can be damaged or destroyed or its functionality impaired through an incorrect
installation.
• Make sure before installing the device that there is no visible damage.
• Ensure that the process connections are clean and that the seals and cable glands are
suitable.
• Mount the device using a suitable tool.
NOTICE
Air circulation around the device
Device damage
The device may overheat in case of heat build-up
• Ensure that there is a su󹪟cient circulation of air around the device.
• If you are installing more than one wall-mounted device, there should be a clearance of ≥
5cm between the sides of the devices.
Installing the device
6.1General safety instructions for installation
Wall-mounted device
60 Operating Instructions, 07/2023, A5E31930403-AB