Engineering and remote access
7.4 SIMATIC STEP 7 in the TIA Portal
Power supply system SITOP PSU8600
182 Manual, 09.2018, A5E36758446-5-76
Buffering The parameters are set here for buffer modules with double-layer
capacitors or UPS modules
Parameterization is only possible if an
appropriate module exists in the system.
• Deactivate the buffer component using a control command.
• Activate the LONGLIFE operating mode (only buffer module
with Double layer capacitors).
• Define the threshold value for the "Sufficient buffer readiness"
message.
• Activate short-time interruption at output 1.
• Time X: Dead time up to the beginning of short time interrup-
tion.
• Time A: Wait time until the short-time interruption.
• Time B: Duration of short-time interruption.
If UPS modules are assigned, then additional parameters can be
defined:
• Time C: Waiting time after client shutdown completed
• Preferred UPS module when the power supply voltage fails
• Define as to whether buffer components are charged before
outputs are activated.
• Define that only one output is activated when starting from a
battery module.
PROFIenergy Here, you activate and configure energy management with
Web interface General Make the following settings:
• Possibility of accessing via a web server (yes/no)
• Automatic logoff when closing the web server (yes/no)
• Permit access only with HTTPS (yes/no)
Automatic up-
date
Make the following settings:
• Activate automatic update (yes/no)
• Time interval for the update
OPC UA
server
OPC UA
Here, activate the OPC UA server.
Unencrypted
access activat-
You have the option of activating unencrypted access to the
OPC UA server. However, this option is not recommended.
OPC UA server
Specify which port should be used.
To Next Page
Loading...
