Engineering and remote access
7.6 Cyclic and acyclic data
Power supply system SITOP PSU8600
264 Manual, 09.2018, A5E36758446-5-76
Index 6: Device information (reading)
Product state Product release Unsigned8
Index 7: Hardware settings (reading)
ChargePower DipSwitch (0/255) Manually set charging power (60 W / 120 W) Unsigned8
PreCharge DipSwitch (0/255)
Setting of DIP switch "PRE CHRG".
StartOnlyOutput1 DipSwitch (0/255)
Setting of DIP switch "START PRY".
Reserved4 DipSwitch (0/255)
Reserved5 DipSwitch (0/255)
Reserved6 DipSwitch (0/255)
Timer1min DipSwitch (0/255)
Setting of DIP switch "+1 MIN" for the buffer timer
Timer2min DipSwitch (0/255)
Setting of DIP switch "+2 MIN" for the buffer timer
Timer5min DipSwitch (0/255)
Setting of DIP switch "+5 MIN" for the buffer timer
Timer10min DipSwitch (0/255)
Setting of DIP switch "+10 MIN" for the buffer timer
Timer20min DipSwitch (0/255)
Setting of DIP switch "+20 MIN" for the buffer timer
Timer50min DipSwitch (0/255)
Setting of DIP switch "+50 MIN" for the buffer timer
Number of connected batteries Number of identified battery modules that are con-
Unsigned16
ModuleIdentNumber subslot 1 Identification number of the battery module at the
Unsigned32
ModuleIdentNumber subslot 2 Identification number of the battery module at the
corresponding position.
Unsigned32
ModuleIdentNumber subslot 3 Identification number of the battery module at the
Unsigned32
ModuleIdentNumber subslot 4 Identification number of the battery module at the
Unsigned32
ModuleIdentNumber subslot 5 Identification number of the battery module at the
Unsigned32