Siemens SITOP PSU8600 - Page 369

Troubleshooting
8.3 Alarm list web server
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
369
ID
Severity
Event
Help text
19 N Overload detected at the output. Output current at the output is above the preset response
threshold but is still within the permissible overload profile.
The output current is about to be limited.
20 N The actual value of the output
current is above the set advance
warning threshold.
The actual value of the output current is above the config-
ured advance warning threshold and is below the response
threshold.
21 MR Output is ready to be switched on. Output is ready to be switched on again after automatic
overload shutdown.
22 N Current limit on the output after
occurrence of an overload.
Output is in overload mode. The output current is limited to
the configured response threshold.
23
N
Output was switched off manually.
Output was switched off manually directly on the device.
24 N Output switched off during buffer-
ing
Output switched off during buffering
25 MR Output is ready to be switched on. Output is ready to be switched on again after automatic
overload shutdown.
26 N Current limit on the output after
occurrence of an overload.
Output is in overload mode. The output current is limited to
the configured response threshold.
27
N
Output was switched off manually.
Output was switched off manually directly on the device.
28 N Output switched off during buffer-
ing
Output switched off during buffering
29 MR Output is ready to be switched on. Output is ready to be switched on again after automatic
overload shutdown.
30 N Current limit on the output after
occurrence of an overload.
Output is in overload mode. The output current is limited to
the configured response threshold.
31
N
Output was switched off manually.
Output was switched off manually directly on the device.
32 N Output switched off during buffer-
ing
Output switched off during buffering
33 MR Output is ready to be switched on. Output is ready to be switched on again after automatic
overload shutdown.
34 N Current limit on the output after
occurrence of an overload.
Output is in overload mode. The output current is limited to
the configured response threshold.
35
N
Output was switched off manually.
Output was switched off manually directly on the device.
36 N Output switched off during buffer-
ing
Output switched off during buffering
37
N
Output was switched off.
Output was switched off.
38
N
Output was switched on.
Output was switched on.
39
N
Output was switched off.
Output was switched off.
40
N
Output was switched on.
Output was switched on.
41
N
Output was switched off.
Output was switched off.
42
N
Output was switched on.
Output was switched on.
43
N
Output was switched off.
Output was switched off.
44
N
Output was switched on.
Output was switched on.
46 F Invalid internal supply voltage. Voltage of the internal supply is too high. All outputs of the
power supply system have been switched off.
47 F Faulty communication to the mo-
dule.
Communication with the expansion module is faulty. All
outputs on the expansion module have been switched off.