Siemens SITOP PSU8600 - Page 370

Troubleshooting
8.3 Alarm list web server
Power supply system SITOP PSU8600
370 Manual, 09.2018, A5E36758446-5-76
ID
Severity
Event
Help text
48 F Critical error A critical error occurred. All outputs of the power supply
(module/system) have been switched off.
49 MD Critical error General critical error occurred. The device may therefore
behave inconsistently.
50 MR General error. General error occurred. Device behavior remains consistent,
however.
51 F Performing firmware update. Performing firmware update. Read/write access is currently
not possible.
52 F Stored module configuration cor-
rupt
Stored module configuration is corrupt. The module cannot
start up correctly.
53 MD Stored module configuration cor-
rupt
Stored module configuration is corrupt. Deviating module
behavior may be possible.
54 MR Stored module configuration cor-
rupt
Stored module configuration is corrupt. Module behavior
remains consistent, however.
55 F Hardware failure A hardware failure has occurred. All outputs of the power
supply system have been switched off.
56
N
Different firmware version detected
Different firmware version detected
57 MR New unconfigured module detect-
ed.
New unconfigured module detected.
58
N
Different serial number detected
Different serial number detected
59 MR Module with excessive power de-
tected.
A module with excessive power was detected. Normal oper-
ation of the system is possible.
60 MR Unexpected module type detected. Unexpected module type detected.
61 MD Module with reduced power de-
tected.
A module with reduced power was detected. Deviating sys-
tem behavior may be possible.
62 F Incompatible module detected. The module has a module type that is incompatible with the
configuration. The module cannot be commissioned.
63
F
Unexpected empty slot detected.
Unexpected empty slot detected.
75 N Parameter out of permissible value
range.
A control command is attempting to set a value outside the
value range that the hardware module can implement. The
value is automatically limited to the minimum or maximum
permitted value for the module.
76 N Parameter out of permissible value
range.
A control command is attempting to set a value outside the
value range that the hardware module can implement. The
value is automatically limited to the minimum or maximum
permitted value for the module.
77 N Parameter out of permissible value
range.
A control command is attempting to set a value outside the
value range that the hardware module can implement. The
value is automatically limited to the minimum or maximum
permitted value for the module.
78 N Parameter out of permissible value
range.
A control command is attempting to set a value outside the
value range that the hardware module can implement. The
value is automatically limited to the minimum or maximum
permitted value for the module.
79 N Parameter out of permissible value
range.
A control command is attempting to set a value outside the
value range that the hardware module can implement. The
value is automatically limited to the minimum or maximum
permitted value for the module.