Siemens SITOP PSU8600 - Page 374

Troubleshooting
8.3 Alarm list web server
Power supply system SITOP PSU8600
374 Manual, 09.2018, A5E36758446-5-76
ID
Severity
Event
Help text
77 N Output switched off during buffer-
ing
Output switched off during buffering
78 MR Output is ready to be switched on. Output is ready to be switched on again after automatic
overload shutdown.
79 N Current limit on the output after
occurrence of an overload.
Output is in overload mode. The output current is limited to
the configured response threshold.
80
N
Output was switched off manually.
Output was switched off manually directly on the device.
81 N Output switched off during buffer-
ing
Output switched off during buffering
82 MR Output is ready to be switched on. Output is ready to be switched on again after automatic
overload shutdown.
83 N Current limit on the output after
occurrence of an overload.
Output is in overload mode. The output current is limited to
the configured response threshold.
84
N
Output was switched off manually.
Output was switched off manually directly on the device.
85 N Output switched off during buffer-
ing
Output switched off during buffering
86 MR Output is ready to be switched on. Output is ready to be switched on again after automatic
overload shutdown.
87 N Current limit on the output after
occurrence of an overload.
Output is in overload mode. The output current is limited to
the configured response threshold.
88
N
Output was switched off manually.
Output was switched off manually directly on the device.
89 N Output switched off during buffer-
ing
Output switched off during buffering
90
N
Output was switched off.
Output was switched off.
91 N Output was switched on. Output was switched on.
92
N
Output was switched off.
Output was switched off.
93
N
Output was switched on.
Output was switched on.
94
N
Output was switched off.
Output was switched off.
95
N
Output was switched on.
Output was switched on.
96
N
Output was switched off.
Output was switched off.
97
N
Output was switched on.
Output was switched on.
98
N
Output was switched off.
Output was switched off.
99
N
Output was switched on.
Output was switched on.
100
N
Output was switched off.
Output was switched off.
101
N
Output was switched on.
Output was switched on.
102
N
Output was switched off.
Output was switched off.
103
N
Output was switched on.
Output was switched on.
104
N
Output was switched off.
Output was switched off.
105
N
Output was switched on.
Output was switched on.
106 N Parameter out of permissible value
range.
A control command is attempting to set a value outside the
value range that the hardware module can implement. The
value is automatically limited to the minimum or maximum
permitted value for the module.