C.1.8 Wizard - Clamp-On Configuration
Open the menu Device→Wizard→Clamp-On Configuration, and follow the steps.
The clamp-on configuration wizard takes the user through the necessary steps to install the
sensors to achieve proper operation.
C.1.9 Wizard - Zero point adjustment
Open the menu Device → Wizard → Inline Configuration, and follow the steps.
Although the device zero is very stable from the factory the user has the ability to remove any
residual zero offset that may exist by performing the Zero Point Adjustment wizard.
SIMATIC PDM
C.1 Commissioning with PDM
SITRANS FST030 (Modbus)
346 Operating Instructions, 08/2018, A5E37367739-AD
To Next Page
Loading...
