Siemens SITRANS FST030 - Page 7

A.9.10.1 Inputs and outputs................................................................................................................319
A.9.10.2 Process values.....................................................................................................................325
A.9.10.3 Alarms ..................................................................................................................................327
A.9.11 Audit trail ..............................................................................................................................329
A.9.11.1 Operating time......................................................................................................................329
A.9.11.2 Parameter change log..........................................................................................................330
A.9.11.3 FW update change log .........................................................................................................331
A.9.12 Device reset .........................................................................................................................332
A.9.13 Oil table settings...................................................................................................................333
A.9.14 Scraper pig detection settings..............................................................................................335
A.9.15 Communication ....................................................................................................................336
A.9.15.1 Service channel....................................................................................................................336
A.9.16 Security ................................................................................................................................336
A.9.16.1 Access management............................................................................................................336
B Certificates and support............................................................................................................................339
B.1 Certificates ...........................................................................................................................339
B.2 Technical support.................................................................................................................339
B.3 QR code label ......................................................................................................................340
C SIMATIC PDM ..........................................................................................................................................341
C.1 Commissioning with PDM ....................................................................................................341
C.1.1 Functions in SIMATIC PDM .................................................................................................341
C.1.2 Supported SIMATIC PDM versions......................................................................................341
C.1.3 Initial setup ...........................................................................................................................341
C.1.4 Integrating the EDD..............................................................................................................342
C.1.5 Adding device to communication network............................................................................343
C.1.6 Configuring a new device.....................................................................................................344
C.1.7 Wizard - Quick Start via PDM ..............................................................................................345
C.1.8 Wizard - Clamp-On Configuration ........................................................................................346
C.1.9 Wizard - Zero point adjustment ............................................................................................346
C.1.10 Changing parameter settings using SIMATIC PDM.............................................................347
C.1.11 Parameters accessed via drop-down menus .......................................................................348
C.1.12 Process variables.................................................................................................................349
Index.........................................................................................................................................................351
Table of contents
SITRANS FST030 (Modbus)
Operating Instructions, 08/2018, A5E37367739-AD 7