Siemens SITRANS LUT400 Series - Page 476

A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 163
mmmmm
Parameters
2.8.2. Low Level Alarm
Reported when material level is within a user-defined range (see 2.8.2.2.Low
Level Value ON and 2.8.2.3.Low Level Value OFF).
2.8.2.1. Enable
Enables/disables Low Level Alarm.
2.8.2.2. Low Level Value ON
Sets the material level (defined in 2.1.1.Units) at which the Low Level Alarm
will activate.
2.8.2.3. Low Level Value OFF
Sets the material level (defined in 2.1.1.Units) at which the Low Level Alarm
will de-activate.
2.8.2.4. Assigned Relay
Determines which relay (if any) will be activated when the Low Level Alarm
activates.
2.8.2.5. Alarm State
Read only. Used to view the current state of the Low Level Alarm.
2.8.3. Switch (Discrete Input) Alarm
Reported when Discrete Input (2.8.3.2.Discrete Input Number) is in a pre-
defined state (2.8.3.3.Discrete Input State).
2.8.3.1. Enable
Enables/disables Switch Alarm.
2.8.3.2. Discrete Input Number
Determines which discrete input to monitor for Switch Alarm.
Options
ENABLED
* DISABLED
Values
Range: 0.000 to 99999.000
Default: 0.000
Values
Range: 0.000 to 99999.000
Default: 0.000
Options
*
NO RELAY
RELAY 1
RELAY 2
RELAY 3
Options
ACTIVE
INACTIVE
Options
ENABLED
* DISABLED
Options
*
DISCRETE INPUT 1
DISCRETE INPUT 2