EasyManuals Logo

Siemens SOMATOM Manual&Nbsp;

Siemens SOMATOM
590 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #108 background imageLoading...
Page #108 background image
108
Workflow Information
Scan
Select single scan protocol or all scan protocols you
want to modify in this subsection. Additionally you can
select the scan mode entries:
– Sequence
– Spiral
– Multiscan
– CAREVision
The displayed parameters depend on the selection you
have made.
• If no special scan mode is selected, the so called
mixed mode is active. The mixed mode means the
user can choose scan ranges from different
modes(Spiral, Sequence, Multiscan, or CAREVi-
sion modes). If the control in one mode is not appli-
cable, the control in mixed mode is not shown in
<Parameters Area>.
A checkbox <Including topogram> is shown below
the parameter grid. When the checkbox is selected, an
information line is added to the parameter grid. The
line is placed immediately before the ranges belonging
to the topogram, you might have to scroll to the right
side of the line to get the information visible.

Table of Contents

Other manuals for Siemens SOMATOM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SOMATOM and is the answer not in the manual?

Siemens SOMATOM Specifications

General IconGeneral
CategoryCT Scanner
Rotation Time0.25 seconds
Tube Voltage70-150 kV
Bore Size78 cm
Max Table Load250 kg
Gantry Aperture78 cm
Table Weight Capacity250 kg
X-ray Tube Voltage70-150 kV
Scan Time per Rotation0.25 seconds
SoftwareSyngo
ConnectivityDICOM

Related product manuals