200mV , 2V , 20V , 200V ,750V
NOTE*:
⚫ All the ranges enable to obtain 20% value higher than original except 750V. Besides, both
Manual and Auto are available for setting every range.
⚫ When inputting range is higher than 750V at 750V Level, “overload” will be shown on the
screen. 750V input protection exists in every range.
4. Set relative value (Optional operation).
Press [Rel] to open or close Relative math function. When it is opened, the reading displayed is
a relative value which comes from the result of actual measurement value subtracts the value
that has been set. (Please refer to “Math Functions” in Chapter 2 to know about the details.)
5. Read measurement result.
Select required measurement rate (reading rate) by pressing [Speed] and read the measurement
result. If you press and then press and to get the frequency value measured
from input AC signal.
Diagram 2-10 Dual-display
6. View history data.
There are four types of way to view historical data: “Number”, “Bar Meter” “Trend Chart” and
“Histogram”.
To Next Page
Loading...
Need help?
General
