SIGLENT TECHNOLOGIES SDM3055 Series User Manual

SDM3055 Series Digital Multimeter User Manual
60 int.siglent.com
I/O Configuration
Press [I/O Config] to enter the following interface and set up the parameters.
Diagram 2-45 I/O Configuration Interface
LAN Settings
The Multimeter enables users to operate instrument remotely by LAN interface and store or recall
internet settings. You can look over current LAN settings and set up IP address and subnet mask.
After entering into the function menu of Utility, press [I/O Config] , Select [on] → [LAN Settings] →
[Modify Settings] to enter the following interface.
Diagram 2-46 LAN Settings Interface
Table 2-16 LAN Settings
Function Menu
Description
IP Address
Set up IP address and the default setting is 10.11.11.104.
Subnet
Mask
Set up subnet mask and the default setting is 255.0.0.0.
Cancel
Cancel current operation and return to the higher-level menu.
Done
Save all changes and return to the higher-level menu.

SIGLENT TECHNOLOGIES SDM3055 Series Specifications

General

Brand	SIGLENT TECHNOLOGIES
Model	SDM3055 Series
Category	Multimeter
Language	English