If the centrifuge is equipped with an automatic rotor identification system,
the input mode will be activated automatically if the system detects a
different rotor with several different types of possible buckets than the rotor
that is set. The bucket that is displayed is the bucket with the lowest
maximum speed. You can only select different types of buckets for the
identified rotor. If the input mode is aborted, this bucket will be stored
nonetheless.
This prevents the maximum permissible speed from being exceeded.
Pos: 141 /010 Univ ersalmodule/ Leerzeile @ 0\mod_12 02116244500 _0.docx @ 1 14 @ @ 1
Pos: 142 /100 Sigm a/100 BA Ze ntrifugen Sigma ( Standardmo dule)/060 Betrieb _Spincontrol L+S/Spincontrol L (Z ent6)/060- 0030-0020- 0091 Beschle unigungs- und Bremskurven - o hne Temp @ 27\mod_140531 9282549_68.docx @ 192843 @ 4 @ 1
→
6.3.2.8 Acceleration and deceleration curves
Acceleration
This function is used to select an acceleration curve. The system offers 10
fixed, programmed acceleration curves (curves 0-9).
Brake
This function is used in order to select a curve that decelerates the
centrifuge to a standstill. Deceleration curves are inverted images of the
acceleration curves and are labelled with identical numbers. Deceleration
curve no. 0 represents a brakeless deceleration.
Fig. 22: Preselection of a curve; here: preselection of an acceleration curve
Pos: 143 /010 Univ ersalmodule/ Seite nwechsel @ 0\mo d_120211624 4312_0.docx @ 105 @ @ 1
To Next Page
Loading...
Need help?
General
