Laboratory Centrifuge Sigma 3-16L
Laboratory Centrifuge Sigma 3-16L IVD
Version 03/2014, Rev. 2.22 of 24/10/2023 • sb
Original operating manual, part no. 0700902
Pos: 144 /100 Sigm a/100 BA Ze ntrifugen Sigma ( Standardmo dule)/060 Betrieb _Spincontrol L+S/Spincontrol L (Z ent6)/060- 0030-0020- 0101 Automatis che Deckelöff nung - ohne Tem p @ 27\mod _1405319285 055_68.docx @ 1 92871 @ 4 @ 1
→
6.3.2.9 Automatic lid opening function ("AutoOpen")
The automatic lid opening function must be activated so that the lid opens
automatically at the end of the operation.
In order to activate the automatic lid opening function:
• Select the "Auto Open" symbol with the cursor and confirm the
selection. The symbol and the bar under the symbol start to flash.
• Activate the function by turning the function knob. The symbol remains
displayed in a permanent manner and the bar continues to flash.
• Turning the function knob further will deactivate the function. In this
case, the symbol disappears but the bar continues to flash.
• Press the function knob in order to activate the desired setting. The bar
remains visible as long as the cursor is placed over the symbol.
Fig. 23: The automatic lid opening function "Auto Open" is activated
Pos: 145 /010 Univ ersalmodule/ Leerzeile @ 0\mod_12 02116244500 _0.docx @ 1 14 @ @ 1
Pos: 146 /100 Sigm a/100 BA Ze ntrifugen Sigma ( Standardmo dule)/060 Betrieb _Spincontrol L+S/Spincontrol L (Z ent6)/060- 0030-0020- 0111 Akustisch es Signal - oh ne Temp @ 27 \mod_140531928 7503_68.docx @ 192899 @ 4 @ 1
6.3.2.10 Sound signal ("Buzzer")
This function is used to set an acoustic warning signal that sounds at the
end of the centrifugation run and also in the event of an imbalance or error
message.
In order to activate the sound signal:
• Select the "Buzzer" symbol with the cursor and confirm the selection.
The symbol and the bar under the symbol start to flash.
• Activate the function by turning the function knob. The symbol remains
displayed in a permanent manner and the bar continues to flash.
• Turning the function knob further will deactivate the function. In this
case, the symbol disappears but the bar continues to flash.
• Press the function knob in order to activate the desired setting. The bar
remains visible as long as the cursor is placed over the symbol.
Fig. 24: The sound signal “Buzzer” is activated
Pos: 147 /010 Univ ersalmodule/ Seitenwechs el @ 0\mo d_120211624 4312_0.docx @ 105 @ @ 1
To Next Page
Loading...
Need help?
General
