Name: Sigma 3-16L
Brand: Sigma
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Laboratory Centrifuge Sigma 3-16L

Laboratory Centrifuge Sigma 3-16L IVD

6 Using the centrifuge

Version 03/2014, Rev. 2.22 of 24/10/2023 • sb

47 / 84

Original operating manual, part no. 0700902

Pos: 153 /010 Univ ersalmodule/ Seitenwechs el @ 0\mo d_120211624 4312_0.docx @ 105 @ @ 1

Pos: 154 /100 Sigm a/100 BA Ze ntrifugen Sigma ( Standardmo dule)/060 Betrieb _Spincontrol L+S/Spincontrol L (Z ent6)/060- 0030-0030 Programmbetri eb -ohne Tem p @ 27\mod_140 5319308365_ 68.docx @ 193 011 @ 3 @ 1

→

6.3.3 Program mode

A program contains all the data that are required for a centrifuge run.

Certain sedimentation results can be repeated under identical conditions.

Programs can be saved, loaded, executed, and edited, when the centrifuge

is at a standstill.

A maximum of 50 programs can be stored under the numbers 1 - 50.

"--" means that the values that are currently set are not a stored program.

The programs can be protected against unauthorised use, modification, or

deletion with the aid of an input lock (see chapter 6.3.2.13 - "Input lock").

Pos: 155 /010 Univ ersalmodule/ Leerzeile @ 0\mod_12 02116244500 _0.docx @ 1 14 @ @ 1

Pos: 156 /100 Sigm a/100 BA Ze ntrifugen Sigma (Standardm odule)/060 Betr ieb_Spincontrol L+S/Spinco ntrol L (Zent6)/060- 0030-0030- 0011 Programm speichern - ohne Temp @ 2 7\mod_14053 19311134_68.d ocx @ 193039 @ 4 @ 1

→

6.3.3.1 Saving a program

NOTE

This function is only available if the centrifuge is at a standstill.

• Enter the parameters that are to be included in the program.

• Select the menu item "save Prog" and confirm the selection. The

indication "save" flashes in the activated status.

• Select a random storage location from the program selection list. Free

storage locations are indicated by a flashing display. Any storage

locations that are already occupied will be overwritten during the saving

process.

• Save the program in the desired location.