Laboratory Centrifuge Sigma 3-16L
Laboratory Centrifuge Sigma 3-16L IVD
8 Maintenance and service
Version 03/2014, Rev. 2.22 of 24/10/2023 • sb
Original operating manual, part no. 0700902
Pos: 190 /100 Sigm a/100 BA Ze ntrifugen Sigma ( Standardmo dule)/080 Wartu ng und Instandh altung/080-0 020-0010 A utoklavieren @ 28\mod_1405 320627440_68. docx @ 19494 3 @ 3 @ 1
→
8.2.1 Autoclaving
The service life of the accessories essentially depends on the frequency of
autoclaving and use.
• Replace the accessories immediately when the parts show changes in
colour or structure or in the occurrence of leaks etc.
• During autoclaving, the caps of the tubes must not be screwed on in
order to avoid the deformation of the tubes.
It cannot be excluded that plastic parts, e.g. lids or carriers, may deform
during autoclaving.
Polycarbonate lids for angle
rotors
Polyallomer lids for angle rotors
Polysulfone lids for angle rotors
Stainless steel tubes and
bottles
Polypropylene copolymer tubes
Stainless-steel balance weight
for blood-bag systems
Pos: 191 /010 Univ ersalmodule/ Seitenwechs el @ 0\mo d_120211624 4312_0.docx @ 105 @ @ 1