Fitting Audio Accessory/Programming Cable
1. On the side of the radio, release the retaining screw and remove the accessory
socket cover.
2. On the audio accessory/programming cable, locate the tab lug of the connector
into either the top or bottom tab hole on the side of the radio as required.
3. Tighten the screw to secure the audio accessory/programming cable to the radio.
Configuration
Before the SDP760 radio can be used it must be configured using the Field Personality
Programmer (FPP). The configuration process loads the customised channels,
signalling and user options so that the radio will operate with the user’s system.
Note: The radio must be upgraded to the correct version associated with the
FPPbeing used.
Upgrade the Radio
If necessary the radio can be upgraded to use new released software. To do this, the
user must first load the radio's software:
1. Put the radio into boot mode by pressing the PTT key and turning the radio on.
2. Connect the radio to the PC.
3. Run the Simoco One Key Update software.
Table 2: One Key Update
4. Click Update.
The user can now program the radio using the FPP software. See the "Program the
Radio" on the next page.
Doc Number: TNM-U-E-0156 Issue: 2.3 Page 4
To Next Page
Loading...
Need help?
General
