Simplex 4010 Service Manual

1-2
System Displays:
"1.02.xx"
System Displays:
Crash Code A?
System Displays:
Any other
Crash Code
Check cable running from keypad to
SFIO Board.
Replace SFIO Board
System Displays:
"Link Scan" followed by
"Code Scan
C123456789A"
System Displays:
"Warm Start Trouble"
Press ACK Key
AC Power LED ON
System
Displays:
Continuos Link Scan/
Code Scan Loop?
Bin File Corrupt, Damaged, or Missing
Replace BIN File or Replace SFIO.
See Note 4.
No Other Troubles or
Crash Codes Present
System Displays:
Crash Codes
See
AC Power
Flowchart
YES
NO
YES
NO
NO
YES
NO
YES
NO
Do Additional Troubles
Appear?
NO
Do Crash Codes Appear?
Refer to Crash Codes in Chapter 3
Refer to Trouble Descriptions in
Chapter 2
System Displays:
"System is Normal"
YES YES
Refer to
Crash Codes
in Chapter 3
NO
YES YES
YES
YES
YES
System Displays:
CFIG Format Mismatch
(~ 10 Seconds)
Versions of Programmer
and BIN File do not match.
See Note 3 Below.
YES
NO
See Note 2
See Note 1
Initial Power Up Flow Chart
Technical Manuals Online! - http://www.tech-man.com

Simplex 4010 Specifications

General

Display	LCD
Power Supply	120/240 VAC, 50/60 Hz
Manufacturer	Simplex
Model	4010
Battery Backup	24 VDC
NAC Outputs	4
Max Detectors	250
Max Modules	250
Operating Temperature	0°C to 49°C (32°F to 120°F)
Humidity Range	Up to 93% RH, non-condensing