4100U-S1 Programming Guide Document: LT0400
Page vi 15 December 2010 Issue 1.4
11 BUILDING AND DOWNLOADING THE CONFIGURATION 11-1
11.1 GENERAL 11-2
11.2 STARTING THE TRANSFER UTILITY 11-3
11.3 SERIAL COMMUNICATION PARAMETER SETTINGS 11-3
11.4 DIRECT CONNECTION TO THE PANEL 11-4
11.5 DOWNLOADING THE CFIG FILE 11-4
11.6 UPLOADING FROM THE PANEL 11-5
11.7 SENDING 4100U FILES TO SIMPLEX. 11-6
12 APPENDICES 12-1
12.1 APPENDIX A – AS4428.1 OPERATION 12-2
12.2 APPENDIX B - COMMON VARIABLES AND CUSTOM CONTROL 12-3
12.2.1 DIGITAL PSEUDO POINTS 12-3
12.2.2 ANALOG POINTS 12-4
12.2.3 LISTS 12-4
12.2.4 PHYSICAL HARDWARE POINTS (LEDS RELAYS ETC) 12-4
12.2.5 BATTERY TEST 12-5
12.2.6 ALARM VERIFICATION TIMING AND START UP SETTINGS 12-5
12.2.7 BRIGADE RELAY EQUATIONS 12-6
12.3 APPENDIX C - CUSTOM CONTROL FOR CONTROL KEYS AND INDICATORS 12-8
12.3.1 COMMON ZONE ALARM LED 12-9
12.3.2 ALARM / FAULT / NORMAL TEST BUTTON AND LEDS 12-10
12.3.3 EXAMPLE ALARM AND FAULT TEST EQUATIONS 12-12
12.3.4 A/C RESET BUTTON AND A/C TRIP LED 12-12
12.3.5 BELLS ISOLATE LED AND BUTTON 12-13
12.3.6 WARNING SYSTEM ISOLATE 12-14
12.3.7 CLEAN UP EQUATIONS 12-14
12.4 APPENDIX D - CUSTOM CONTROL FOR ALARM ZONE FACILITIES 12-16
12.4.1 DIGITAL POINTS USED 12-16
12.4.2 LISTS 12-17
12.4.3 SWITCHES AND LEDS 12-17
12.4.4 ZONE 1 EQUATIONS 12-17
12.4.5 ZONE N EQUATIONS 12-18
12.5 APPENDIX E - 4100-1282 AZF SWITCH AND LED ADDRESS MAPPING 12-20
12.6 APPENDIX F – USEFUL PSEUDO POINTS AND LISTS 12-22
To Next Page
Loading...
Need help?
General
