Simplex 4190 Graphical - System Requirements; System Requirements for Windows 95 Computers; System Requirements for Windows 3.1 Computers

2-2
In order for a Microsoft® Windows 95-based computer platform to operate
properly as a GCC, it must meet or exceed the following minimum hardware
requirements.
• An IBM-compatible personal computer with a Pentium Processor
• 850 Mb (or greater) Hard Drive
• 3.5 inch, high-density floppy disk drive
• 1 parallel port
• 1 serial port
• 16 Mb RAM (32Mb recommended)
• SVGA graphics controller
• Monitor
• A mouse, touchscreen monitor, or both
• A 733-794 Serial Download Cable
• A 740-907 Software Key
• If an SDACT is installed, you will need the SDACT Programmer
software (Part No. 553-807).
In order for a Microsoft® Windows 3.1-based computer platform to operate
properly as a GCC, it must meet or exceed the following minimum hardware
requirements.
• 33 MHz 486 Central Processing Unit (CPU)
• 85 Mb hard drive
• 3.5 inch, high-density floppy disk drive
• 1 parallel port
• 1 serial port
• 8 Mb RAM
• SVGA graphics board
• Monitor
• A mouse, touchscreen monitor, or both
• A 733-794 Serial Download Cable
• A 740-907 Software Key
Continued on next page
System Requirements
System Requirements for
Windows 95 Computers
System Requirements for
Windows 3.1 Computers
firealarmresources.com