3-6
This section describes the installation of the Touchscreen software (driver) for
Windows 95.
1. Install the Elo Touchscreen hardware as described in the Intellitouch or
AccuTouch Product manual or the Quick Start Poster. Make sure to
configure the Touchscreen with resources that are not already in use by
other devices (COM port, IRQ, etc.).
2. Start your computer.
3. Insert the MonitorMouse for Windows 95 disk into the floppy disk drive
(typically, drive A).
4. Click the Start button to invoke the Windows 95 system menu, and choose
Run from that menu.
5. Type “a:\setup” in the message box and click OK or press <Enter>.
6. Follow the directions on the screen.
7. The Touchscreen Setup wizard will appear. You will need to specify the
type of touchscreen controller you are using and how it is connected.
8. Set the Controller Type to “PC-Bus AccuTouch 2201,” IRQ to “IRQ5,” and
Base I/O Port to “280.”
9. Complete the Setup program.
10. Remove the disk from the floppy disk drive.
11. Restart the computer.
This section describes the installation of the Intellipoint mouse software (driver)
for Windows 3.1.
1. Insert the Microsoft Intellipoint for Microsoft Mouse into Drive A.
2. From Windows Program Manager, select the File Run menu option. The
system displays a box.
3. Type A:setup in the box and select OK.
4. Use the default values during installation.
Continued on next page
Installing the Software, Continued
Installing Touchscreen
Software (Windows 95)
Installing Mouse Software
(Windows 3.1)
To Next Page
Loading...
