5-1
This chapter describes how to connect 2120 nodes to a GCC using the existing
RS-232 Serial Port.
Note: To connect 2120 nodes using the multiport card, refer to the SLI
Multiport Option - Installation Instructions, Publication 574-097.
This chapter discusses the topics listed in the following table. Refer to the page
number listed after the topic for information on that topic.
Topic See Page #
Hardware Requirements 5-2
Connecting the 2120 Nodes to the GCC 5-3
Chapter 5
Connecting 2120 Nodes
Introduction
In this Chapter
To Next Page
Loading...
