The range zoom bars on the right side of the display shows the
range that is magnified. If you increase the zooming factor the
range is reduced. You see this as reduced distance between the
zoom bars.
Move the zoom bars up/down on the image to view different
depths of the water column.
Bottom lock
The bottom lock mode is useful when you want to view targets
close to the bottom. In this mode, the left side of the panel shows
an image where the bottom is flattened. The range scale is changed
to measure from the seabed (0) and upwards. The bottom and the
zero line are always shown on the left image, independent of the
range scale. The scaling factor for the image on the left side of the
panel is adjusted as described for the Zoom option.
Palettes
Use for selecting the image's color palette.
Temperature graph
The temperature graph is used to illustrate changes in water
temperature.
When toggled on, a colored line and temperature digits are shown
on the image.
Depth line
When toggled on, a line is shown on the bottom surface. The depth
line makes it easier to distinguish the bottom from fish and
structures.
Amplitude scope
The amplitude scope is a display of an echo sounding on the panel.
The strength of the actual echoes are indicated by both width and
color intensity.
Zoom bar
Select to display the zoom bar while the image is zoomed. For
information how to use the zoom bar, refer to "Zoom bar" on page 147.
154
Echosounder | GO XSE/XSR Operator Manual
To Next Page
Loading...
Need help?
General
