Communication error
If a communication error occurs between the MFD and the CZone
digital switching device, an error message is shown in the control
bar.
Power-Pole anchors
Power-Pole anchors, which can be controlled by the C-Monster
Control System installed on your boat, can be controlled from the
unit. To control the Power-Poles, you pair the Power-Poles with the
unit using Bluetooth wireless technology available in both products.
Power-Pole controls
When Bluetooth is enabled, the Power-Pole button becomes
available in the control bar. Select it to display the Power-Pole
controller.
For pairing Bluetooth devices, refer to "Bluetooth options" on page 202.
If you are pairing dual Power-Poles, also review "Pairing with dual Power-
Poles" on page 233.
When the Power-Pole controller is opened, the system connects to
paired Power-Poles. When the connection is confirmed, the control
buttons are enabled.
The Power-Pole controller displays control buttons for each Power-
Pole that is paired to the unit.
Single press the AUTO buttons to raise and lower the Power-Poles
automatically all the way up and down. The manual up and down
buttons raise and lower the poles as high or low as you want.
232
Integration of 3 party devices | GO XSE/XSR Operator
Manual
To Next Page
Loading...
Need help?
General
