Simrad GO XSE Series User Manual

Waypoint
Navigates to the selected waypoint, and then maintains the vessel
at that position.
Here
Maintains the vessel at the current position.
Change the position in anchor mode
Use the arrow buttons to reposition the vessel when in anchor
mode. Each press on a button will move the anchor position 1.5 m
(5 ft) in the selected direction.
Heading lock mode
In this mode the autopilot steers the vessel on the set heading.
When the mode is activated, the autopilot selects the current
compass heading as the set heading.
Ú
Note: In this mode the autopilot does not compensate for any
drifting caused by current and/or wind (W).
To change the set heading
• Select a port or starboard button
An immediate heading change takes place. The heading is
maintained until a new heading is set.
NAV mode
Warning: NAV mode should only be used in open
waters.
Prior to entering NAV mode you must be navigating a route or
towards a waypoint.
In NAV mode the autopilot automatically steers the vessel to a
specific waypoint location, or along a pre-defined route. Position
information is used to change the course to steer to keep the vessel
on the track line and to the destination waypoint.
When arriving at the destination, the autopilot switches to the
selected arrival mode. It is important to select an arrival mode that
W
Trolling motor autopilot | GO XSE/XSR Operator Manual
91

Simrad GO XSE Series Specifications

General

Brand	Simrad
Model	GO XSE Series
Category	Marine Equipment
Language	English