4-13
Printer Management
Envelope
You can feed up to 5 envelopes into the MPT.
Use envelop made with 75 - 90g/m2 (20- 24lb) of quality paper.
Do not use the following types of paper.
With metal rings, binding thread, or binding rings
Stuck together
Damaged in any form
Bent sharply
With holes, cuts, or sashes
With a mail stamp
With adhesive material applied on the fold of the envelope
Use an envelope that is not bent, rolled or not discharging any harmful substances at 205℃ (401℉).
If uncertain, check with the envelope supplier.
Select the correct envelope size after setting the tray to Manual and the paper type to Envelope in the
printer driver. Put the folded part of the envelope facing down and have the side with receiver’s address
enter the printer first.
Important
- Depending on the application environment and the envelope state, an envelope may be wrinkled.
Envelope opened a long time ago may be bent or expanded making it difficult to be fed.
In this case, load it after flattening the side of the envelope that will be fed first, especially the corners.
Label Paper
Label paper is provided in letter or A4 size. The adhesive part of label paper, the paper printed, and
the protective film part should endure the 205℃ (401℉) of temperature and 25 lb/psi of pressure for
proper usage.
Test a sheet of the label paper to be used before purchasing the paper in a mass quantity.
Do not use the label paper with the adhesive surface exposed.
Card Stock
Card stock is heavy one-fold paper. Depending on the features such as humidity, thickness, and texture,
the card stock may affect the print quality. Card stock can be fed only through the multipurpose tray.
Be sure to test the card before purchasing it in a mass quantity.
To Next Page
Loading...
