Sindoh A413dn - Printer Settings Check; Turning on the Printer; Printing the System Report Page

2-19
Printer Installation
8. Printer Setting Check
Turning on the printer
1
Connect the end of the power cord to the port on the back of the printer and plug the power cord to
the properly grounded wall outlet.
2
Switch on the printer.
When initial warming-up is complete, the message [Ready] will appear to indicate the printer is ready
to receive data.
If the message other than [Ready] appears, see 「Understanding Printer Messages」 p. 3-17.
3
Check your PC and see if other devices are on.
4
Move on to the next step.
Caution
- Leaving the printer with power switched off for a long time may result in abnormal images.
Printing the System Report Page
Print the system report to see initial settings and check if options are properly installed.
1
Check if the printer is on.
2
Press
【◀】, 【▶】
to enter [Menu].
3
Press
【▶】
to find [Report]. Then press 【OK】.
4
Check whether [System Report] has been selected. Then press【OK】
5
If options are not displayed, switch off the device, unplug the power cord, and then install options again.
6
Check the tray and paper type.