Using the Printer
3-11
Menu Purpose Value
Assign
Default Tray
Default Tray Settings Select the default tray that will feed paper first; *Tray 1, Tray 2,
Tray 3 or MPT. Trays 2 and 3 only appear when they have been
installed. Tray with the same size and type of paper will auto
-
matically be connected.
To cancel automatic connection, change tray settings so that
each tray has a different setting.
Sustitute
A4/LT
Replace it when the
printing paper size is
different from the paper
feeder size.
Yes or NO
(*) is default factory setting.
Default factory setting may be different according to region.
General Menu Settings
Menu Purpose Value
Power Save Time before entering Power Save mode (min.)
* Auto Power Save Mode: An automatic power
saving mode transition function through
analysis/memory of printer usage patterns
0 ~ 240 (Disabled when 0)
* Auto Power Save Mode
Auto reset time Time setting (in minutes) to change modified
settings or screens to default settings.
Not used, 10 seconds to 600
seconds
Busy P. Sleeptime The set standby time will be applied before
going into Powersave mode if any printing
operation occurred during the time period of
the past week (min)
1 ~ 60
(1*)
Idle P. Sleeptime The set standby time will be applied before
going into Powersave mode if no printing
operation occurred during the time period of
the past week (min)
1 ~ 60
(1*)
Time Setup Device time setting function
Time zone Not used, 10 seconds to 600 seconds
Boozer Boozer on/off settings On/Off
Language Control Panel Language Settings *Korean, English
Factory Default The firmware update through the network Firmware update
No/Yes
To Next Page
Loading...
