Using the Printer
3-22
Note
- For WEP, the 64-bit or 128-bit WEP encryption key is used.
WPA/WPA2:
Enter the WPA key. If a connection is successfully made, wireless network setting is complete.
Note
- Just as with WEP, WPA uses TKIP (Temporal Key Integrity Protocol) and AES(Advanced
Encryption Standard) for data encryption.
Enterprise WPA/Enterprise WPA2 (Wireless IEEE802.1x&EAP):
In the case of enterprise WPA/enterprise WPA2, for user authentication, you must enter the user ID
and password. See “Entering Wireless Security Password” and follow the LCD message to enter
the user ID and password. If a connection is successfully made, wireless network setting is complete.
Entering Wireless Security Password
Enter the IP according to the procedures below;
①When the password window appears, enter the password to access the wireless AP.
When characters (upper case English, lower case English, numbers, or symbols) appear by pressing
【◀】or【▶】, enter the 【OK】 button to input.
② To enter text, use the number keypad. Press number keys repeatedly to change
number to upper case -> lower case -> “ ”.
③ Use arrows to enter symbols. Use 【◀】,【▶】 to select a symbol on the control panel and press 【OK】.
To see symbols on the next page, use 【▲】,【▼】 arrow keys.
To modify a value, press [Clear/
] button to erase previous value.
④ Repeat ② and ③ to enter the wireless AP password.
⑤ After entering the password to the last digit, press the 【◀】,【▶】 button to connect with the selected SSID.
⑥ To cancel input, press the 【
】 button. You will go to the upper menu.
Caution
- For your convenience, each password character is displayed. Be careful not to expose the wireless AP
password to others.
To Next Page
Loading...
