SINTERIT Lisa X - Page 44

Sinterit LISA X User Manual | 44
20. Put on a new breglass rope by wrapping it four times around the Print Bed. Remember not to stretch the breglass
rope (g. 12.26).
21. Use a clean, plastic spatula while pressing down the breglass rope (g. 12.27).
22. Finish sealing at the starting point. Using scissors cut off excess breglass cord.
Fig. 12.26 Put on new breglass sealing. Fig. 12.27 Use a plastic spatula to press down the sealing.
23. Put on the Print Bed cover (g. 12.28).
24. Using a 2,5 mm allen key, tighten the four screws securing the Print Bed cover (g. 12.29).
Fig. 12.28 Put on the Print Bed cover. Fig. 12.29 Tighten the four screws securing the Print Bed cover.
25. Good job. The maintenance timer will reset to zero.